The distance between the thug and the rib should be adjusted

The carding 150D DTY YARN is not good, and it may even be caused by a small gap at a point pressing on the cylinder. 46 What should be paid attention to in the installation, flattening, wiping, and key maintenance work of the cotton catcher? A: We often say that the garden plate seems simple, but it is difficult to do well! Leaing to work on large and small flat cars and installing garden disks has basically leaed half of the techniques of Qinghua. 3. What is the appropriate cover speed? Answer:

The distance between the thug and the rib should be adjusted between 4 and －4 mm according to the actual production situation. After driving, there is no obvious vibration of the beater. Cause greater waste. The cotton roll that adjusts the cotton supply of the cotton box is not pinched out.

There is too much difference in neps between one section of sliver, and there may be damage to the clothing, such as: scratches or slight scratches on some parts of the cylinder, doffer, spur roller, cover plate clothing, etc. After the stretcher belt is stretched or damaged due to traffic jam, long wear time, try to replace both of them at the same time, otherwise, because one is loose and the other is under uneven stress, neither will be used for too long.5 to 2. 2. Various specifications of reducer umbrella gear teeth are strictly prohibited from misuse. 3.

The general control is 0. Therefore, it is necessary to do a good job of cleaning the magnetic roller, reduce the entanglement, and keep the rotor flexible, so that the distance between the two ends of the magnetic roller can be low inside and high outside the cotton bale. What are the main causes and preventive measures of 50 thick rolls? Answer:

The main reasons for the thick and thin rolls: 1. 49 Rieter C4 model, the speed of the movable cover is 220mmr/min, but there is a gear on the machine, I am currently changing the slowest to 110mmr/min. Under the condition of ensuring the normal supply of production, the smaller the drop distance of the gripper of the cotton gripper is, the higher the disk operation rate is.